Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Sweep Across Westchester
If you’re searching for a chimney sweep in Westchester, the first thing to understand is that most chimneys here don’t look like the ones in fireplace magazines. A large share of Westchester homes never had a chimney to begin with; the vent you’re looking at was likely added later for a gas or prefabricated fireplace. That changes what a sweep actually involves, and it’s the reason we start every visit with inspection rather than a brush. We know the difference between a flue that needs cleaning and a metal cap that’s been leaking storm water into your surround. Call (844) 560-6429 and we’ll set up a visit. We answer 24/7.
Why Westchester Homeowners Call Anchor Chimney Sweep for Chimney Sweep
Westchester is a heavily Cuban-American suburb, and much of its housing went up as ranch homes in the 1950s through the 1970s, with a wave of Mediterranean-style houses following in the 1980s. Most of those homes were built without fireplaces. When a fireplace or stove shows up today, it’s usually a later addition, and the trades who installed it didn’t always leave the venting in a condition a homeowner can check on their own. That’s the gap we fill.
Homeowners across Westchester call us because we treat the whole assembly as one system: the vent, the cap, the flashing, the surround, and the appliance. We’re not a handyman with a brush. Our technicians have up to 8 years of experience, we’re licensed and insured, and every visit includes a camera inspection with a photo record you keep. If you’re buying or selling a home in Westchester and need a credible inspection before closing, that same discipline applies. One call covers the sweep, the inspection, and any repair, so you’re never handed off to a separate contractor to finish what the inspection found.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Fireplace Cleaning in Westchester
Fireplace Cleaning in Westchester usually means something different than it does up north. Because so many fireplaces here are decorative or gas units, the cleaning step is often light, while the inspection step carries the weight: checking the vent for rust, the cap for looseness, and the surround for water staining. A typical fireplace cleaning in Westchester runs $125 to $225. If your unit has never burned wood, we’ll tell you plainly and won’t charge you for scrubbing soot that isn’t there. We’ll show you what the camera sees before recommending anything.
What the Cleaning Covers
We remove any loose soot and debris, vacuum the firebox and surround, and wipe down the glass and interior panels on gas units. After a summer of heavy rain, the more useful part of the visit is checking for moisture that’s found its way past the cap. The goal is a clean appliance and a clear picture of its venting.
Telling Cleaning Apart From Repair
When the camera shows a rusted cap or failed flashing, that’s a repair, not a cleaning, and we say so before any work begins. You’ll see the footage yourself. Nothing gets recommended without evidence you can look at.
Chimney Services in Westchester
Chimney Services in Westchester start with diagnosis, because the most common mistake in this market is assuming a sweep is what’s needed. When a decorative or gas fireplace hasn’t been used as a wood burner, a routine brushing does nothing for the actual problem, which is often a rusted cap or water intrusion after a storm. Chimney services here typically run $150 to $650 depending on scope. If your flue liner is deteriorating, HeatShield liner restoration offers a documented, manufacturer-backed alternative to full liner replacement. We’ll give you the written estimate up front.
Inspection-First Service
A Level 1 or Level 2 inspection comes before any cleaning or repair recommendation. The Level 2 uses a camera so we can see the full length of the vent, which matters on prefab units where the liner is out of sight. We record what we find and hand it to you.

Creosote and Soot Removal
On the rare wood-burning appliance in Westchester, creosote is a real concern, and third-degree creosote needs proper removal rather than a quick brush. We handle that work as part of the sweep, and we don’t skip camera verification on these units just because they’re uncommon here.

Trusted Brands We Service in Westchester
We work with and install products from HeatShield, Gelco, Olympia Chimney, Famco, and the other lines professional chimney contractors rely on nationwide. We don’t claim to stock parts, but we can source the correct cap, damper, or vent cover for your system rather than substituting generic hardware, and we’ll tell you the realistic lead time when we quote. For Westchester homeowners, that access matters: a correct-fitting Famco cap that actually seals against monsoon rain does more for your fireplace than a cleaning that was never needed. HeatShield gives us a proven path to restoring a compromised liner without tearing the whole thing out.
Common Chimney Sweep Problems We See in Westchester Homes
- Rusted caps after hurricane-season storms. Metal components in a tropical monsoon climate take on water intrusion and corrosion far faster than wood-burning setups build up creosote. Many of these caps have never been inspected since installation.
- Failed flashing around the vent. Heavy summer rain finds the seam between the flashing and the roof, then shows up as a stain near the fireplace. This is a water-protection repair, not a sweep.
- Chimneys that were never designed for the appliance vented into them. On the occasional wood-burning unit, an older stack may have been fitted to a stove or insert it wasn’t built for, and the liner takes the stress.
- Sweeps called for soot that isn’t there. A homeowner notices a musty smell on a gas unit, assumes the chimney needs brushing, and ends up paying for a cleaning when the real issue is a water-damaged surround.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Sweep in Westchester, FL
Pricing for a chimney sweep in Westchester is set per job by a written estimate, and the estimate is free. Here’s what’s typical for this market, as a guide:
| Service | Typical Westchester range |
|---|---|
| Annual sweep | $125 to $225 |
| Level 1 inspection | $99 to $175 |
| Level 2 camera inspection | $175 to $325 |
| Creosote and soot removal | $150 to $450 |
| Cap or flashing repair | $200 to $600 |
| HeatShield liner restoration | $1,200 to $3,200 |
What moves you up or down the range is access, the condition of the cap and flashing, and whether the vent turns out to be metal or masonry. Because so many Westchester chimneys are prefab or gas, a lot of visits that start as a sweep turn into an inspection with a small moisture repair, which usually costs less than a full cleaning-and-liner conversation. We’d rather tell you that up front than sell you work your vent doesn’t need. Call (844) 560-6429 for an exact quote – estimates are free.
We Also Serve Cities Near Westchester
We work throughout Westchester and out into the surrounding communities: Olympia Heights, Coral Terrace, Tamiami, and West Miami. The neighboring cities share the same housing patterns, so the same inspection-first approach applies whether you’re just south of us or a few miles west. To see the full set of towns we cover, visit our Westchester service area page.
Serving Westchester, FL – Our Local Coverage Area
We serve Westchester and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs About Chimney Sweep in Westchester
Usually not in the traditional sense, but you do need an inspection. Gas fireplaces produce little or no soot, so a brushing does almost nothing. What matters is the vent: rust, a loose cap, or water getting past the flashing after storm season. We start with a camera inspection and only recommend cleaning if there’s actually something to remove. Call (844) 560-6429 for an exact quote – estimates are free.
Look for water stains on the ceiling or wall near the fireplace, a musty smell when the unit is off, or visible rust on the cap or vent. Those are the common signs in Westchester, where water intrusion is a more frequent problem than creosote. A camera inspection confirms exactly where the water is getting in before we recommend a fix. Call (844) 560-6429 for an exact quote – estimates are free.
A Level 2 inspection uses a camera to examine the full length of the vent and liner, including the parts you can’t see from the firebox. It matters here because most Westchester vents are prefab or gas units with metal liners out of sight, and those are where rust and water damage hide. You get the photo record from the camera so you can see what we see. Call (844) 560-6429 for an exact quote – estimates are free.
Yes, when a wood-burning appliance in Westchester has built up third-degree creosote, we remove it as part of the sweep. This is the glazed, hardened type that a standard brush won’t touch and that raises fire risk, so it warrants proper removal by a trained technician. We confirm the buildup on camera before quoting the work. Call (844) 560-6429 for an exact quote – estimates are free.
No, caps and flashing are repair work rather than part of a sweep, and they’re quoted separately. In Westchester, that repair is often the real reason a homeowner called in the first place, since a rusted cap or failed flashing lets monsoon rain into the surround. We show you the evidence and the written estimate before anything is approved. Call (844) 560-6429 for an exact quote – estimates are free.
What Happens When You Call
Book a visit and we’ll come out, run the camera, and give you a written estimate with the findings attached. If the honest answer is that your gas fireplace needs a new cap rather than a sweep, that’s what you’ll hear, and if the work can safely wait, we’ll say so. A chimney is a system, and we inspect, clean, and repair it as one. Call (844) 560-6429. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Anchor Chimney Sweep.